Skip to content
SearchFree account
Menu
Powertrain · Exhaust and emissions

P0056Oxygen sensor heater, bank 2, sensor 2: control circuit fault

What does it mean?

An only works when it is hot. A built-in heater makes sure it is ready soon after a cold start. The sees an electrical fault in that heater or its control. Sensor 2 sits after the on bank 2: the side without 1. Only engines in V or boxer layout have a bank 2.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • on
  • Slightly higher consumption just after a cold start
  • Usually nothing noticeable while driving

Common causes

  • Burnt-out heater inside the sensor (the sensor is then replaced as a whole)
  • Blown fuse for the sensor heaters
  • Damaged wiring or a melted plug near the exhaust

What you can check yourself

  • Check the fuse for the heaters (see the owner's manual)
  • Look for melted or chafed wires near the exhaust

What to ask the garage

  • Was the resistance of the heater measured?
  • Is it the sensor, the fuse or the wiring?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes