With a pedal sensor fault, the engine often limits power or only idles. Drive calmly to a safe place if it happens on the road.
What does it mean?
The accelerator pedal has two sensors that measure how far you press it. The control unit compares them to make sure the engine never gives power you did not ask for. The voltage is higher than a working part can deliver. Usually that points to a broken ground or signal wire, a loose plug, a short to a supply wire or a defective part.
This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.
What you may notice
- Engine warning light on
- Engine in emergency mode or reacts little to the pedal
- Sometimes only idle speed
Common causes
- Worn pedal sensor
- Loose or corroded plug at the pedal
- Chafed wiring in the footwell
- Water damage, for example from a leak or a wet floor mat
What you can check yourself
- Check that no floor mat or object presses against the pedal
- Look under the dashboard to see whether the plug on the pedal is firmly in place
What to ask the garage
- Is the pedal unit defective, or the wiring?
- Do both pedal sensors show matching values in the live data?
Checked on 14 November 2026