What does it mean?
The control units in your car exchange data over a network (the CAN bus). Another control unit can no longer reach the vehicle security (immobiliser) unit. It checks the key before the engine may start. The cause can be that unit itself, its power supply or the network wiring.
This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.
What you may notice
- Warning lights of the system concerned
- Functions of that system do not work or work only partly
- Often several network codes at the same time
- Sometimes only once, after a flat battery or jump-start
Common causes
- Flat battery, low voltage or a blown fuse for that unit
- Corroded plug or water damage
- Damaged network wiring
- Defective control unit
What you can check yourself
- Check whether the battery is in good condition and the terminals are tight
- Note whether the code appeared after a flat battery, jump-start or repair
- Check whether the functions of this system work
What to ask the garage
- Does the unit get power and ground?
- Can the unit be reached with a diagnostic tool?
- Is it the unit or the network wiring?
Checked on 14 November 2026