Skip to content
SearchFree account
Menu
Powertrain · Ignition and engine timing

P0339Crankshaft position sensor: signal drops out now and then

Important

The engine can suddenly stall or fail to restart, often when warm. Avoid trips where stalling would be dangerous until it is fixed.

What does it mean?

This sensor tells the the and the exact position of the crankshaft. Without that signal, it does not know when to inject and ignite. The signal disappears or jumps for a moment. That usually points to a loose contact, a chafed wire or a plug with corrosion, often worse with vibration, heat or damp.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • Engine stalls, often when warm
  • Engine cranks but does not start
  • Rev counter drops out
  • Jerking

Common causes

  • Defective sensor (often heat-sensitive)
  • Loose or corroded plug
  • Damaged wiring
  • Dirt or metal particles on the sensor, or a damaged reluctor ring

What you can check yourself

  • Note whether the problem happens mainly when the engine is warm
  • Watch whether the rev counter drops out just before stalling

What to ask the garage

  • Is the sensor or the wiring at fault?
  • Was the reluctor ring checked for damage?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes