What does it mean?
This sensor measures the pressure before and after the particulate filter, so the control unit knows how full the filter is and when to clean it. Without a reliable value, regeneration does not work properly. The control unit sees an electrical fault in this circuit. Most often that is a broken wire, a corroded or loose plug, or a defective part.
This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.
What you may notice
- Engine warning light or particulate filter light on
- Regeneration happens too often or not at all
- Sometimes emergency mode
Common causes
- Loose, cracked or melted pressure hoses
- Hoses mixed up after a repair
- Defective sensor
- Loose plug or damaged wiring
What you can check yourself
- Look at the small hoses from the filter to the sensor: are they firmly in place and undamaged?
- With the engine off, the measured pressure difference in the app should be close to zero
What to ask the garage
- Are the hoses connected the right way round?
- Is the sensor itself defective?
Checked on 14 November 2026