Skip to content
SearchFree account
Menu
Using the app

The dashboard explained

What each part of the Car-Z dashboard shows: the top bar, layouts and gauges, live values, warnings, the trip, fault codes and readiness. And what is free.

2 min readUpdated 14 November 2026

The top bar

  • The name of your car. Tap it to change the name.
  • The connection status: connected, or reconnecting when the connection dropped.
  • The warm-up indicator: "Engine cold" until the oil (or else the ) reaches about 70 °C, then "Warmed up".
  • The (), if your car reports it.
  • The buttons "Inspection report", "" and "Disconnect".

Layouts and gauges

Above the gauges you choose a layout: "Daily", "Towing" or "Track". In "Daily" the large gauges show speed, rpm and . A small marker shows the highest value of this trip. only means something on a engine; on other engines it stays around zero.

With "Edit layout" you choose which gauges you see and in which order.

What is free and what is Plus

Free shows the basic values: rpm, speed, and battery, plus the warnings and the . The other live values, the chart, the trip card, , the and your own layouts are in Plus. In their place you see a calm card "In Plus"; everything that is free keeps working.

Temperatures and live values

Not every car reports every value. Anything your car does not provide shows a dash. The chart shows rpm and over the last two minutes.

  • Temperatures: , engine oil, intake air and outside air.
  • Battery: the voltage of the car's electrical system. With the engine running, this is the .
  • Fuel level, , , and fuel rate.

Warnings

Car-Z shows a red bar when a value is clearly out of the ordinary: a very high or oil temperature, a low battery, a that is too high, or a that suggests the is not charging. A warning is a signal to pay attention, not a diagnosis. The warnings are always free.

Trip, fault codes and readiness

The card "This trip" shows the duration, distance, average speed and the highest values. A trip starts by itself as soon as the engine runs.

Under "" you see the codes with a short explanation, marked stored, pending or permanent. With Plus you also see the . The "Clear codes" button is here too.

The panel shows which emission are ready, and answers the question "Codes recently cleared?".

Was this guide helpful?

Your answer is only saved on this device.

Ready to read your car?

Plug in your dongle, switch on the ignition and open the app.

All guides