Skip to content
SearchFree account
Menu
Fault codes and inspection

Checking a used car step by step

Before you buy: read the fault codes, check whether codes were cleared recently and watch the live values during a test drive. Ten minutes that can save you a lot of money.

2 min readUpdated 18 November 2026

Before the viewing

  • Take your and a charged phone with Car-Z (Chrome on Android, on iPhone). Apps for Android and iPhone: expected in December.
  • Ask the seller whether you may plug in a diagnostic . A seller with nothing to hide rarely objects.
  • If possible, ask for the engine to be cold when you arrive. Warm-up behaviour tells you a lot.

Read the codes and the readiness monitors

  1. Plug in the , switch the ignition on and connect.
  2. Compare the shown in Car-Z with the one on the registration papers and on the car itself.
  3. Open "" and look at stored, pending and .
  4. Look at the . On a car that is driven normally, almost all of them are "ready".
  5. Check what Car-Z says under "Codes recently cleared?".

Were the codes cleared recently?

A seller can clear to switch off the . The fault itself is still there, but you cannot see it right away. Clearing does leave traces, though: the go back to "not ready", and many cars keep track of the distance and time since the codes were cleared.

Car-Z combines these signals into one clear answer. If many monitors are "not ready" or the codes were cleared only a short distance ago, ask the seller why.

During the test drive

  • Watch the : it should rise steadily to operating temperature and stay there.
  • With the engine running, the should be roughly 13.5 to 14.8 volts.
  • Look out for warnings in Car-Z and for that appear after the drive.
  • Set everything up before you drive off and do not operate the phone while driving.

Save and share the inspection report

Tap "Inspection report" while you are connected. Car-Z turns the result into a report on this device: , with , , and the answer to "Codes recently cleared?". Use "Print or save as PDF" to share it with a garage or with the seller. The report, and the are part of the Car-Z check in Plus. Only checking one car? Then the one-off occasion check is enough.

Was this guide helpful?

Your answer is only saved on this device.

Ready to read your car?

Plug in your dongle, switch on the ignition and open the app.

All guides