What does it mean?
ABS stops the wheels from locking when you brake hard, so you can still steer. When the ABS light stays on, the system has switched itself off because of a fault.
The normal brakes still work, but without the help of ABS. On many cars stability control (ESP) switches off as well, because it uses the same sensors.
The most common cause is a faulty wheel speed sensor or its wiring, or dirt on the sensor ring. A fault in the ABS unit itself or a low battery voltage can also cause it.
What can you do?
- Keep more distance and brake earlier, especially on wet or slippery roads.
- Does the red brake warning light come on as well? Stop as soon as it is safe and do not drive on.
- Have the system read out and repaired by a garage soon.
What can Car-Z do with it?
Car-Z can read part of thisPartly. ABS faults are stored in the ABS control unit, which standard OBD2 usually does not read. Some cars do report them over OBD2, as C codes such as C0035; Car-Z shows them when your car provides them. Often a garage needs brand-specific equipment.
Related fault codes
These codes are stored by the car when it finds the fault behind this light, as far as the car reports them over OBD2.
- C0035Wheel speed sensor left front: circuit faultPlan a garage visit
- C0040Wheel speed sensor right front: circuit faultPlan a garage visit
- C0045Wheel speed sensor left rear: circuit faultPlan a garage visit
- C0050Wheel speed sensor right rear: circuit faultPlan a garage visit
- C0110ABS unit: pump motor circuit faultPlan a garage visit
- C0121ABS unit: valve relay circuit faultPlan a garage visit
- U0121Lost communication with the ABS control unitPlan a garage visit
This page is an indication, not safety advice. Symbols, colours and the meaning differ per make and model: always check the owner's manual of your car. When in doubt, contact a garage or roadside assistance.
Content checked on 14 November 2026.