What does it mean?
The gear wheel with an exclamation mark, or a message, warns of a problem in the gearbox. On automatic and dual-clutch gearboxes it often means the gearbox is too hot or has detected a fault.
To protect itself the gearbox can switch to an emergency mode: it stays in one gear, shifts roughly or gives less power. Overheating happens sooner when towing or in slow traffic on hills.
Possible causes are low or old transmission fluid, a faulty sensor, a solenoid valve or a clutch problem in a dual-clutch gearbox.
What can you do?
- Gearbox too hot (often shown with a message or thermometer): stop as soon as it is safe and let it cool down as your owner's manual describes.
- Fault light or emergency mode: drive calmly and have it read out soon. With loss of drive or strange noises, stop as soon as it is safe.
- Do not tow a trailer until the cause is known.
What can Car-Z do with it?
Car-Z can read part of thisPartly. Many cars report gearbox faults over OBD2 as P07xx codes (such as P0700 and P0730), and sometimes a too high fluid temperature as a code (P0218). Car-Z reads and explains them when your car provides them.
Related fault codes
These codes are stored by the car when it finds the fault behind this light, as far as the car reports them over OBD2.
- P0700Transmission control unit reports a faultPlan a garage visit
- P0715Transmission speed sensor, input shaft: circuit faultPlan a garage visit
- P0730Incorrect gear ratio, generalPlan a garage visit
- P0740Torque converter lock-up clutch: circuit faultPlan a garage visit
- P0750Shift solenoid A: circuit faultPlan a garage visit
- P0218Transmission fluid too hotStop now
- P0868Transmission fluid pressure too lowPlan a garage visit
This page is an indication, not safety advice. Symbols, colours and the meaning differ per make and model: always check the owner's manual of your car. When in doubt, contact a garage or roadside assistance.
Content checked on 14 November 2026.